Chassis modification will be required for the front right side along the transmission tunnel using a hammer or rubber mallet. This can be done without removing the carpet.
Does not work with factory seats or OEM seats.
Only fit most aftermarket seats that are side-mounted
Customer Reviews
3.0Based on 2 Reviews
5 ★
0%
0
4 ★
0%
0
3 ★
100%
2
2 ★
0%
0
1 ★
0%
0
Customer Photos
Write a ReviewAsk a Question
Reviews
Questions
Thank you for submitting a review!
Your input is very much appreciated. Share it with your friends so they can enjoy it too!
Purchased this bracket , some hammering was required for it to fit flush on the front right corner , overall will be purchasing another bracket , attempted to mount two seats , bride zeta required me to add spacers on both sides and sparco evo 2 did not fit . Would confirm that your seat fits before purchasing
Quality of the material is good. I did have to hammer my trans tunnel for the bracket to sit flush. I have an older (08’) sparco prodrive seat, and the base of the seat is much more narrow than the side mounting plates of the bracket. I used longer bolts and extra nuts to retain a tight/solid position. I think it’s important to notify prior to purchase that the item is NOT a direct fit. For my application the NA/NB with the slider sides would have been a easier application. Otherwise a great improvement for lowering your seat position. Thx
United States
